# Contributed by Mark Nienberg

# sensors-detect 2.10.6 suggested the w83627thf chip, but that is wrong. The

# board actually has a Winbond W83792D according to the manual.

# Here are configurations for Winbond W83792AD/D chip.

chip "w83792d-*"

    label in0 "VCoreA"

    label in1 "VCoreB"

    label in2 "VIN0"

    label in3 "VIN1"

    label in4 "VIN2"

    label in5 "VIN3"

    label in6 "5VCC"

    label in7 "5VSB"

    label in8 "VBAT"

# These are the corresponding fan names from motherboard manual.

# Rear_Fan1 through Rear_Fan4 are not read by lm_sensors, but the manual

# says that all fans are controlled by "smart fan" in BIOS.

# fan6 doesn not show up in sensor output for me.

    label fan1 "Frnt_Fan3"

    label fan2 "Frnt_Fan1"

    label fan3 "Frnt_Fan2"

    label fan4 "Frnt_Fan4"

    label fan5 "Frnt_Fan5"

#   label fan6 "Nothing"

    label fan7 "Frnt_Fan6"

# Here is my installed fans layout

# Yours will be different

#    ignore fan1

#    label fan2 "Case Fan"

#    ignore fan3

#    label fan4 "CPU1 Fan"

#    label fan5 "P/S Fan"

#    ignore fan6

#    ignore fan7

# Fix Case fan because speed read 0 at low speeds.

#    set fan2_div 8

# Temps - I'm guessing here.

# Add 5 degrees to CPU temperatures to match BIOS

# (very limited data on which to base this)

    compute temp2 @+5,@-5

    compute temp3 @+5,@-5

    label temp1 "MB Temp"

    label temp2 "CPU1 Temp"

    label temp3 "CPU2 Temp"

# Ignore chassis alarm, I don't have one

    ignore chassis

# prevent alarm on in0, the actual value is about 1.1

# this is probably due to my low power 55 watt CPU

    set in0_min 0.8

    set in0_max 1.6