This chapter gives a brief introduction into the sample tools using one of the tests as example. It assumes that you are already familiar with Intel(R) Processor Trace (Intel PT) and that you already built the decoder library and the sample tools. For detailed information about Intel PT, please refer to chapter 11 of the Intel Architecture Instruction Set Extensions Programming Reference at http://www.intel.com/products/processor/manuals/.
Start by compiling the loop-tnt test. It consists of a small assembly program with interleaved Intel PT directives:
$ pttc test/src/loop-tnt.ptt loop-tnt-ptxed.exp loop-tnt-ptdump.exp
This produces the following output files:
loop-tnt.lst a yasm assembly listing file loop-tnt.bin a raw binary file loop-tnt.pt a Intel PT file loop-tnt-ptxed.exp the expected ptxed output loop-tnt-ptdump.exp the expected ptdump output
The latter two files are generated based on the @pt .exp(<tool>) directives
found in the .ptt file. They are used for automated testing. See
script/test.bash for details on that.
Use ptdump to dump the Intel PT packets:
$ ptdump loop-tnt.pt 0000000000000000 psb 0000000000000010 fup 3: 0x0000000000100000, ip=0x0000000000100000 0000000000000017 mode.exec cs.d=0, cs.l=1 (64-bit mode) 0000000000000019 psbend 000000000000001b tnt8 !!. 000000000000001c tip.pgd 3: 0x0000000000100013, ip=0x0000000000100013
The ptdump tool takes an Intel PT file as input and dumps the packets in human-readable form. The number on the very left is the offset into the Intel PT packet stream in hex. This is followed by the packet opcode and payload.
Use ptxed for reconstructing the execution flow. For this, you need the Intel
PT file as well as the corresponding binary image. You need to specify the load
address given by the org directive in the .ptt file when using a raw binary
file.
$ ptxed --pt loop-tnt.pt --raw loop-tnt.bin:0x100000 0x0000000000100000 mov rax, 0x0 0x0000000000100007 jmp 0x10000d 0x000000000010000d cmp rax, 0x1 0x0000000000100011 jle 0x100009 0x0000000000100009 add rax, 0x1 0x000000000010000d cmp rax, 0x1 0x0000000000100011 jle 0x100009 0x0000000000100009 add rax, 0x1 0x000000000010000d cmp rax, 0x1 0x0000000000100011 jle 0x100009 [disabled]
Ptxed prints disassembled instructions in execution order as well as status messages enclosed in brackets.