This target is only valid in the

.B nat

table, in the

.B POSTROUTING

chain.  It should only be used with dynamically assigned IP (dialup)

connections: if you have a static IP address, you should use the SNAT

target.  Masquerading is equivalent to specifying a mapping to the IP

address of the interface the packet is going out, but also has the

effect that connections are

.I forgotten

when the interface goes down.  This is the correct behavior when the

next dialup is unlikely to have the same interface address (and hence

any established connections are lost anyway).

.TP

\fB\-\-to\-ports\fP \fIport\fP[\fB\-\fP\fIport\fP]

This specifies a range of source ports to use, overriding the default

.B SNAT

source port-selection heuristics (see above).  This is only valid

if the rule also specifies one of the following protocols:

\fBtcp\fP, \fBudp\fP, \fBdccp\fP or \fBsctp\fP.

.TP

\fB\-\-random\fP

Randomize source port mapping

If option

\fB\-\-random\fP

is used then port mapping will be randomized (kernel >= 2.6.21).

.TP

\fB\-\-random-fully\fP

Full randomize source port mapping

If option

\fB\-\-random-fully\fP

is used then port mapping will be fully randomized (kernel >= 3.13).

.TP

IPv6 support available since Linux kernels >= 3.7.